Product no.: HFP1
HFP-1
Follow up of the legendary MP1 Portabel Vertical incl. 80m Coil. Operational Length abt. 2,25m (50MHz-7MHz), 2,40m (3,5MHz) Max power 200W. Transport Length only 37cm. |
110.00 €
*
Shipment from Stock: 7 |
|
Product no.: HFP1Standfuss
Tripoid for HFP1, 30cm legs
|
34.00 €
*
Shipment from Stock: 2 |
|
Product no.: VBeta-MatchBausatz
Beta-Match kit for MP-1 and HF-P1 Under certain earth conditions the length of the coaxial cable is unusually sensitive to the tuning, at the same time the foot resistance at the resonance frequency is in the range of 20-25 Ohm. I could observe the whole thing especially on 40m, but not yet on the higher bands. The solution to use 4 10m long radials is a little reluctant for me, because it counteracts the main advantage of the MP1. I've found another solution that always works in extreme conditions at the first go: A beta match directly to the foot and a mantle wave barrier directly behind it. The whole thing fits into the Fuchskreis housing and can be screwed directly onto the MP-1/HF-P1 foot. Kit contains all necessary components incl. drilled housing and self adhesive label |
25.00 €
*
Shipment from Stock: 3 |
|
Product no.: VBeta-MatchFERTIG
Beta-Match for MP-1 and HF-P1 (ready to use) Under certain earth conditions the length of the coaxial cable is unusually sensitive to the tuning, at the same time the foot resistance at the resonance frequency is in the range of 20-25 Ohm. I could observe the whole thing especially on 40m, but not yet on the higher bands. The solution to use 4 10m long radials is a little reluctant for me, because it counteracts the main advantage of the MP1. I've found another solution that always works in extreme conditions at the first go: A beta match directly to the foot and a mantle wave barrier directly behind it. FACTORY ASSEMBLED |
39.00 €
*
Shipment from Stock: 2 |
|
Product no.: AX1
ELECRAFT AX1 |
140.00 €
*
Shipment: |
|
Product no.: AX2
AX2 MINATURE 20-METER WHIP ANTENNA.
The AX2 is small enough to take anywhere - just in time for light outdoor use during the new solar cycle. Use it HT-style with a handheld tripod like the KX2, on a picnic table with an AXB1 whip tripod, or with a camera tripod and the AXT1 tripod adapter. The AX2's rugged nylon housing is waterproof, wind resistant and features our new anti-wobble design. Experimenters will appreciate the AX2's versatile design. A removable cover allows access to the high-Q inductor. Simply remove the windings and re-solder a wire to cover your favorite ribbon. Clip-off tabs are provided for ribbon identification. SPECSResonant Frequencies AX2: ~14 MHz (20 m) AXE1: ~7.2 MHz (40 m) Resonant frequencies may vary +/- 400 kHz or more due to variations in terrain,antenna height, body capacitance, and length of radial(s). Supplied Radial Wire AX2: 13 ft. (4 m). AXE1: 33 ft. (10 m). Includes spade lug. Max. Power 15 Watts. If RFI symptoms are observed, reduce power or move the antenna farther from the transceiver. Construction Corrosion-resistant whip and hardware; Lexan outer tube; high-Q inductors using #20 AWG high-temp enamel wire. Dimensions (approx.) Whip: 6” (15 cm) collapsed, 45” (115 cm) extended. Base unit: 2.5” (6 cm). AXE1 extender: 6” (15 cm). Weight AX2: 3.2 oz. (90 g). AXE1: 2.0 oz. (55 g).
|
102.00 €
*
Shipment: |
|
Product no.: AXE1
AXE1 40m extender
extension to use the AX1 Antenna on 40m and 30m (internal ATU needed!)
delivery include: 40m extension coil (15cm) radial wire (10m) |
77.00 €
*
Shipment from Stock: 12 |
|
Product no.: AXT1
AXT1 |
32.00 €
*
Shipment: |
|
Product no.: AXB1
AXB1 |
40.00 €
*
Shipment: |
|
Product no.: E770064 |
8.90 €
*
Shipment: |
|
Product no.: DL1
Elecraft 25W Dummy Load 50 Ohm
|
43.00 €
*
Shipment: |
|
Product no.: UG-306U
BNC Male-Female Right Angle Adapter
|
3.50 €
*
Shipment: |
|
Product no.: plst-plst
PL-PL connector, PTFE isolation, gold plated contact
|
2.20 €
*
Shipment from Stock: 17 |
|
Product no.: DipIt
Complete Kit for the most sensitive Dipmeter you ever have seen. Contains all parts and a ready punched unpainted enclosure.
|
155.00 €
*
|
Product no.: DipAnalyzer
Easy but helpull: 50 Ohm Wheatstone RF bridge with amplified Display as an AdOn for our Dipmeter. The Resonate Frequency of an Antenna can be detected fast and easy.
|
32.00 €
*
Shipment: |
|