KX3 Transceiver     

• 160-6 meters, SSB/CW/DATA/AM/FM modes
• 10 W PEP (100 W with KXPA100 amp)
• Only 1.5 pounds (0.7 kg)
• Current drain as low as 150 mA
• Internal wide-range antenna tuner (ATU) and battery options; built-in speaker
• Advanced DSP provides dual watch, noise reduction, noise blanking, auto-notch, stereo audio effects
• Software-defined radio (SDR) architecture plus roofing filters (KXFL3) for excellent dynamic range
• Operates in data modes (PSK31/RTTY) with or without a PC; includes RX I/Q soundcard output
  
  ATTENTION: The Microphon is optional! If you want it, you find it below, put it into the basket, also you have to order the ATU or the roofing filter seperately if you want!
  The antenny you see on the KX3 picture ist only for demonstration, it´s NOT available from Elecraft or QRPproject! 

installation of later ordered options in KX3 by QRPproject

8-inductor/8-capacitor L-network provides very wide matching range and fast tuning.

Multiple per-band memories provide nearly instant re-tune. Operates even in receive, improving selectivity ahead of receiver.

Includes filter elements to optimize AM broadcast band receive (0.5-1.6 MHz).

Safely and automatically charges 8 NiMH cells in the KX3's internal 8-AA battery pack from an external 12-15 V supply.

Charge time varies depending on cell capacity and depth of discharge; 8 hours typical. Includes real-time clock, providing time display and alarm.

The KXPD2 is a very compact mechanical keyer paddle that attaches directly to the front of KX2 (or KX3). This eliminates the need for a heavy keyer base. It includes a slot in which to store the contact-adjustment wrench.

The KX3-PCKT cable set interfaces between the Elecraft KX3 and personal computers, and provides convenient connection to an external foot switch and RF power amplifier.

SignaLink cable to connect an Elecraft KX3

• High-performance companion panadapter for the Elecraft KX3 transceiver
• Full-color waterfall and spectrum displays, with fast sweep and excellent sensitivity
• Simple plug-and-play operation—no PC, soundcard, software drivers or setup required
• Weighs just 13 oz (0.37 kg); enclosure size: 5.4 x 3.4 x 1.7” (13.7 x 8.6 x 4.3 cm) 

2M All-Mode Internal KX3 Option (User Installed. For KX3's with NO KXAT3)

Adapter cable RG316 with SMA male to BNC female. 15cm long pigtail.

addtional cable for KX3 (KX3 basic has inlcuded one)